Homemade CNC from plywood.
Recently my friend and colleague Beehiwe assembled and tested homemade CNC machine.
No Comments
Cheap radio channel for AVR
Good day. I recently wondered to organize radio communications between microcontrollers AVR. The budget was very limited, and therefore as a controller for the test i selected two Atmega8 which have long idle lying . When i start search of experimental transceiver I was unpleasantly surprised by the prices of radio modules, so on that money that I expected in Ukraine could only buy a “pair receiver – transmitter board” at 433 MHz . But I wanted a full duplex link so I started looking in an Internet suitable option. It was a 2.4 GHz radio module. NRF24L01 drew the attention certainly of its price.
In the basic version without amplifier and the antenna on the printed circuit board. At the time of this writing a article couple of these modules on ebay can be bought for $ 3.23
